Difference between revisions of "Sensor / Trinket Template"

From Microduino Wiki
Jump to: navigation, search
(Digital Read)
(Arduino IDE)
 
(2 intermediate revisions by the same user not shown)
Line 56: Line 56:
 
</syntaxhighlight>
 
</syntaxhighlight>
  
{|style="border-down:10px;border-right:10px"
+
{|
|'''Description:<t>'''
+
|'''Description:'''
 
|Reads the current value of the Crash Sensor.
 
|Reads the current value of the Crash Sensor.
 
|-
 
|-
|'''Arguments: '''
+
|'''Arguments:'''
 
|pinNum - the pin number that the Crash Sensor is connected to.
 
|pinNum - the pin number that the Crash Sensor is connected to.
 
|-
 
|-

Latest revision as of 20:37, 22 February 2019

Microduino Crash-rect.jpg

Introduction

The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.

Technical Specifications

  • SKU / module number: MSDS11
  • Operating voltage: 5V
  • Connectors: n/a
  • Chip Used: n/a
  • Schematics: File:Na
  • Dimensions:

Compatible Pins

Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.

This module requires a digital input compatible pin as shown below:

image of compatible pins

Hardware Setup

The bare minimum hardware configurations to used this module is as follows:

Microduino Series

Microduino Crash-rect.jpg
  • 1x of the following core modules: Microduino Core, Microduino Core+, Microduino CoreUSB, or Microduino CoreRF
  • 1x Microduino USBTTL
  • 1x Microduino Connector Hub
  • 1x Connector Wire
  • 1x Crash Sensor

mCookie Series

Microduino Crash-rect.jpg
  • 1x of the following core modules: mCookie Core, mCookie Core+, mCookie CoreUSB, or mCookie CoreRF
  • 1x of the following core programmers: mCookie USB-TTL, or mCookie mBattery (built-in programmer)
  • 1x mCookie Connector Hub
  • 1x Connector Wire
  • 1x Crash Sensor

mCookie Series (using mCenter+)

Microduino Crash-rect.jpg
  • 1x mCenter+ (built-in mCookie Core+ & programmer)
  • 1x Connector Wire
  • 1x Crash Sensor

Usage

Arduino IDE

Digital Read

digitalRead(pinNum)
Description: Reads the current value of the Crash Sensor.
Arguments: pinNum - the pin number that the Crash Sensor is connected to.
Return: true or high when the Crash Sensor is NOT pressed.
false or low when the Crash Sensor is pressed.