Difference between revisions of "Sensor-Servo Connector"

Sensor-Servo_Connector

The product number of Sensor-Servo Connector is: MSDO41

Sensor-Servo Connector is used to link the servo with the interface of extension module.

Introduction of Pins

Pins of the sensor: PIN1: GND PIN2: VCC General signal pins: PIN3(IO1): digital/analog signal PIN4(IO2): NC(null) Special signal pins: If it is IIC: IO1/IO2 are respectively SDA/SCL. If it is soft serial port: IO1/IO2 are respectively tx/rx.

Special to Sensor-Servo Connector sensor pins PIN1: GND PIN2: VCC PIN3(IO1): IO1 PIN4(IO2): IO2 Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub.

The servo can not link with the extension module (hub) directly, so a servo connector is needed. The servo connector have 3 above pins and 3 below pins, which can connect to two servos at the same time.

When connecting the servo and the sevo connector, please pay attention to the "positive and negative" , and make sure that the GND, VCC, and 1/2 three wires are connected rightly. The above pins is corresponding to the odd pins of Hub, and the below pins is corresponding to the event pins of Hub. For example, when connecting the servo to the 6/7 pin of Hub, if the servo is connected to the below pins, the control pin is 6; to the above pins is 7.

Application

Used to connect up to 2 Servos to the 4 pin header on a Sensor Hub.

Purchase

Gallery