Difference between revisions of "Mixly Block Category - SerialPort"
(→Serial Write) |
(→Serial Write) |
||
| Line 11: | Line 11: | ||
=Serial Write= | =Serial Write= | ||
Writes binary data to the serial port. This data is sent as a byte or series of bytes; to send the characters representing the digits of a number use the print() function instead. | Writes binary data to the serial port. This data is sent as a byte or series of bytes; to send the characters representing the digits of a number use the print() function instead. | ||
| + | |||
Read more here: https://www.arduino.cc/en/Serial/Write | Read more here: https://www.arduino.cc/en/Serial/Write | ||
Revision as of 00:47, 22 February 2017
Serial is used for communication between the Microduino / Arduino board and a computer or other devices. All Microduino / Arduino boards have at least one serial port (also known as a UART or USART): Serial. It communicates on digital pins 0 (RX) and 1 (TX) as well as with the computer via USB. Thus, if you use these functions, you cannot also use pins 0 and 1 for digital input or output.
Read more here: https://www.arduino.cc/en/Reference/Serial
Contents
Serial Baud Rate
Sets the data rate in bits per second (baud) for serial data transmission. For communicating with the computer, use one of these rates: 300, 600, 1200, 2400, 4800, 9600, 14400, 19200, 28800, 38400, 57600, or 115200.
Read more here: https://www.arduino.cc/en/serial/begin
Serial Write
Writes binary data to the serial port. This data is sent as a byte or series of bytes; to send the characters representing the digits of a number use the print() function instead.
Read more here: https://www.arduino.cc/en/Serial/Write
Serial Print
Serial PrintLn
Serial PrintLn(Hex)
Serial Availability
Serial Read String
Serial Read String Until Character Delimitation
Serial Read
- read
- peek
- parseInt
- paraseFloat
