Difference between revisions of "Crash (use with mDesigner)"

From Microduino Wiki
Jump to: navigation, search
(Created page with "The Crash switch (also know as Crash sensor) is a sensor which is able to detect if the switch/button pressed or not pressed. Support for this trinket is found in mDesigner....")
 
Line 1: Line 1:
The Crash switch (also know as Crash sensor) is a sensor which is able to detect if the switch/button pressed or not pressed. Support for this trinket is found in mDesigner.
+
The Crash switch (also know as Crash sensor) is a sensor which is able to detect if it is pressed or not pressed. The state of the Crash switch can be detected and can be used to trigger events or conditions in scripts. Support for this trinket is found in mDesigner.
  
 
=Compatible Pins=
 
=Compatible Pins=

Revision as of 17:23, 7 June 2018

The Crash switch (also know as Crash sensor) is a sensor which is able to detect if it is pressed or not pressed. The state of the Crash switch can be detected and can be used to trigger events or conditions in scripts. Support for this trinket is found in mDesigner.

Compatible Pins

The following pins on the Hub or mCenter+'s Hub support this module:

Hub Digital Pins v2-01.png
Pin Name Compatibility Notes
Pin 0 Yes Not recommended, Pin 0 & 1 used by mDesigner (serial communication).
Pin 1 Yes Not recommended, Pin 0 & 1 used by mDesigner (serial communication).
Pin 2 Yes
Pin 3 Yes
Pin 4 Yes
Pin 5 Yes
Pin 6 Yes
Pin 7 Yes
Pin 8 Yes
Pin 9 Yes
Pin 10 Yes
Pin 11 Yes
Pin 12 Yes
Pin 13 Yes
Pin A0 Yes
Pin A1 Yes
Pin A2 Yes
Pin A3 Yes
Pin A6 Yes
Pin A7 Yes
Pin I2C No


Blocks