Difference between revisions of "Template:Sensor explain"
From Microduino Wiki
| (3 intermediate revisions by the same user not shown) | |||
| Line 5: | Line 5: | ||
[[file:sensor_backpin.png|130px|left]] | [[file:sensor_backpin.png|130px|left]] | ||
|width="40%" valign="top" align="left"| | |width="40%" valign="top" align="left"| | ||
| − | *'''Pins of the sensor''' | + | *'''Pins of the sensor''': |
| − | ** | + | **PIN1: '''GND''' |
| − | ** | + | **PIN2: '''VCC''' |
| − | **General signal | + | **General signal pins: |
| − | ***PIN3(IO1) | + | ***PIN3(IO1): '''digital/analog signal''' |
| − | ***PIN4(IO2) | + | ***PIN4(IO2): '''NC(null)''' |
| − | **Special signal | + | **Special signal pins: |
| − | ***IIC | + | ***If it is IIC: '''IO1/IO2 are respectively SDA/SCL'''. |
| − | *** | + | ***If it is soft serial port: '''IO1/IO2 are respectively tx/rx'''. |
|width="40%" valign="top" align="left"| | |width="40%" valign="top" align="left"| | ||
| − | *<div class="nameA"> | + | *<div class="nameA">Special to '''{{{nameA|A}}} sensor pins'''</div> |
| − | ** | + | **PIN1: '''GND''' |
| − | ** | + | **PIN2: '''VCC''' |
| − | **<div class="modeA">PIN3(IO1) | + | **<div class="modeA">PIN3(IO1): '''{{{modeA|pin mode}}}'''</div> |
| − | **<div class="modeB">PIN4(IO2) | + | **<div class="modeB">PIN4(IO2): '''{{{modeB|pin mode}}}'''</div> |
| − | Microduino | + | Microduino sensor can communicate with core module through the connection with [[Microduino-Module Sensor Hub]]. |
|} | |} | ||
Latest revision as of 07:49, 19 September 2016
 |
|
Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub. |
