The guide below is a software setup guide for Windows aimed for general use of Microduino products.

For kit specific getting started guides please follow the appropriate links in the #Kit_Specific_Software_Setup_Guides section:

Kit Specific Software Setup Guides

Itty Bitty City

mCookie 101 Basic

mCookie 201 Advanced

mCookie 301 Expert

mCookie 102 Basic

mCookie 202 Advanced

mCookie 302 Expert

If your kit is not listed, please proceed following the general setup guide below.

Previous Installations

Download

Download the latest Windows Microduino IDE (Version 6.0, 2020-02-27): HERE
Download the previous Windows Microduino IDE (Version 5.0, 2019-03-25): HERE

Installation

1. Double click on the setup file to start the installation process. Click Next.

2. The next window will allow you to select which options to install. Leave all checked and click Install.

3. The installation process will begin for the Arduino IDE.

4. Wait until it is complete.

5. After the Arduino IDE has been installed, a window for driver installation will appear. Click Next.

6. Click on "I accept this agreement" and click Next to start the drivers installation.

7. After the drivers are installed, click Finish.

8.Installation is now complete! Click on Finish.

9.If you left the run option checked, the software will start to launch. Otherwise locate the program shortcut on your desktop or start menu and launch it.

10. The software is now ready to be used!

Confirm Drivers Installed Successfully

Confirm that the drivers are installed successfully based on your hardware.

Refer to the table below for which programmer each kit uses:

• NOTE: CoreUSB is a core module with an integrated programmer.

USBTTL

• Connect Microduino-USBTTL to your computer. Verify that there are available Port options under Tools.

CoreUSB

• Connect Microduino-CoreUSB or mCookie-CoreUSB to your computer. Verify that there are available Port options under Tools.

mBattery

• Connect mCookie-Battery to your computer.

IMPORTANT: Ensure that mBattery is "ON" by pressing and holding the button. A red LED should be on, which indicates that power is being supplied to the modules. mBattery must be "ON" in order to program the modules.

• Verify that there are available Port options under Tools.

Selecting Board Type and Processor

Selecting the Board Type and Processor is required to compile the correct code for the core module.

Configuring the software is done under Tools > Board and Tools > Processor.

Below is the table which lists all the core modules with corresponding Board and Processor. The table also lists kits that contain specific core modules.

Example usage would be for the Core module in Itty Bitty City. Board is Microduino/mCookie-Core (328p) and Processor is Atmega328P@16M,5V.

Determining Processor Variant

Core

Core+

Arduino IDE Basics

Interface

• [Verify]: Checks for errors in the code.

• [Upload]: Uploads the program to a MCU.

• [Serial Monitor]: Useful in debugging programs.

Tools

• [Board]: Select the corresponding core module to which the program is being uploaded.

• [Processor]: Select the corresponding processor.

• [Port]: Select the common USB port.

Uploading Code

1. Select board type and processor.
2. Select the port.
3. Click upload.

• Note: If using mBattery to upload to a core module. Ensure that mBattery is "ON" and supplying power to the modules. There will be a red LED on.