Difference between revisions of "Sensor / Trinket Template"
From Microduino Wiki
(→Arduino IDE) |
(→Arduino IDE) |
||
| (6 intermediate revisions by the same user not shown) | |||
| Line 56: | Line 56: | ||
</syntaxhighlight> | </syntaxhighlight> | ||
| − | + | {| | |
| − | {| | + | |'''Description:''' |
| − | |'''Description''' | ||
|Reads the current value of the Crash Sensor. | |Reads the current value of the Crash Sensor. | ||
|- | |- | ||
| − | |'''Arguments''' | + | |'''Arguments:''' |
|pinNum - the pin number that the Crash Sensor is connected to. | |pinNum - the pin number that the Crash Sensor is connected to. | ||
|- | |- | ||
| − | |'''Return''' | + | |'''Return:''' |
|'''true''' or '''high''' when the Crash Sensor is NOT pressed. | |'''true''' or '''high''' when the Crash Sensor is NOT pressed. | ||
|- | |- | ||
Latest revision as of 20:37, 22 February 2019
Contents
Introduction
The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.
Technical Specifications
- SKU / module number: MSDS11
- Operating voltage: 5V
- Connectors: n/a
- Chip Used: n/a
- Schematics: File:Na
- Dimensions:
Compatible Pins
Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.
This module requires a digital input compatible pin as shown below:
Hardware Setup
The bare minimum hardware configurations to used this module is as follows:
Microduino Series
mCookie Series
mCookie Series (using mCenter+)
Usage
Arduino IDE
Digital Read
digitalRead(pinNum)| Description: | Reads the current value of the Crash Sensor. |
| Arguments: | pinNum - the pin number that the Crash Sensor is connected to. |
| Return: | true or high when the Crash Sensor is NOT pressed. |
| false or low when the Crash Sensor is pressed. |
