Difference between revisions of "Touch (use with mDesigner)"
From Microduino Wiki
(→Compatible Pins) |
(→Digital Read Pin) |
||
| Line 103: | Line 103: | ||
==Digital Read Pin== | ==Digital Read Pin== | ||
This block reads the state of the pin. In Arduino, this is known as a digital read (digitalRead). A value of either 0 or 1 will be returned. | This block reads the state of the pin. In Arduino, this is known as a digital read (digitalRead). A value of either 0 or 1 will be returned. | ||
| − | *When | + | *When Touch sensor is '''NOT PRESSED''', '''1''' is returned. |
| − | *When | + | *When Touch sensor is '''PRESSED''', '''0''' is returned. |
::[[File:MDesigner_Digital_Read.png]] | ::[[File:MDesigner_Digital_Read.png]] | ||
:*'''Pin Number''' - the pin number to read from. | :*'''Pin Number''' - the pin number to read from. | ||
Revision as of 20:22, 7 June 2018
The Touch sensor (also know as Touch button) is a sensor which is able to detect if it is pressed or not pressed based on capacitance (read more). The state of the Touch sensor can be detected and can be used to trigger events or conditions in scripts. Support for this sensor is found in mDesigner.
Compatible Pins
The following pins on the Hub or mCenter+'s Hub support this module:
| Pin Name | Compatibility | Notes |
|---|---|---|
| Pin 0 | Yes | Not recommended, Pin 0 & 1 used by mDesigner (serial communication). |
| Pin 1 | Yes | Not recommended, Pin 0 & 1 used by mDesigner (serial communication). |
| Pin 2 | Yes | |
| Pin 3 | Yes | |
| Pin 4 | Yes | |
| Pin 5 | Yes | |
| Pin 6 | Yes | |
| Pin 7 | Yes | |
| Pin 8 | Yes | |
| Pin 9 | Yes | |
| Pin 10 | Yes | |
| Pin 11 | Yes | |
| Pin 12 | Yes | |
| Pin 13 | Yes | |
| Pin A0 | Yes | |
| Pin A1 | Yes | |
| Pin A2 | Yes | |
| Pin A3 | Yes | |
| Pin A6 | Yes | |
| Pin A7 | Yes | |
| Pin I2C | No |
Blocks
Digital Read Pin
This block reads the state of the pin. In Arduino, this is known as a digital read (digitalRead). A value of either 0 or 1 will be returned.
- When Touch sensor is NOT PRESSED, 1 is returned.
- When Touch sensor is PRESSED, 0 is returned.
- Pin Number - the pin number to read from.
Pin Is
This block reads the state of the pin, then compares it to the configured state.
- If the state of the pin DOES MATCH the configured state, then this block returns true
- If the state of the pin DOES NOT MATCH the configured state, then this block returns false
- Pin Number - the pin number to read from.
- State - state to match in order for this block to return true.
- HIGH tests if the Crash switch is NOT PRESSED.
- LOW tests if the Crash switch is PRESSED.
