Difference between revisions of "Sensor / Trinket Template"
From Microduino Wiki
(Created page with "thumb|right =Introduction= The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch. =Te...") |
|||
| Line 11: | Line 11: | ||
*'''Schematics:''' [[File:na]] | *'''Schematics:''' [[File:na]] | ||
*'''Dimensions:''' | *'''Dimensions:''' | ||
| + | |||
| + | =Compatible Pins= | ||
| + | Use a connector wire to connect this module to either a [[Microduino Hub module]], [[mCookie Hub module]], [[mCenter+]], or any other boards which accepts the standard 4-pin connector for a sensor / trinket. | ||
| + | |||
| + | This module requires a '''digital input''' compatible pin as shown below: | ||
| + | |||
| + | [[image of compatible pins]] | ||
| + | |||
| + | =Hardware Setup= | ||
| + | The bare minimum hardware configurations to used this module is as follows. | ||
| + | ==Microduino Series== | ||
| + | *1x a Microduino core module (Core, Core+, CoreUSB, CoreRF) | ||
| + | *1x Microduino USBTTL | ||
| + | *1x Microduino Connector Hub | ||
| + | *1x Connector Wire | ||
| + | *1x USB Cable | ||
| + | ==mCookie Series== | ||
Revision as of 22:43, 31 January 2019
Contents
Introduction
The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.
Technical Specifications
- SKU / module number: MSDS11
- Operating voltage: 5V
- Connectors: n/a
- Chip Used: n/a
- Schematics: File:Na
- Dimensions:
Compatible Pins
Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.
This module requires a digital input compatible pin as shown below:
Hardware Setup
The bare minimum hardware configurations to used this module is as follows.
Microduino Series
- 1x a Microduino core module (Core, Core+, CoreUSB, CoreRF)
- 1x Microduino USBTTL
- 1x Microduino Connector Hub
- 1x Connector Wire
- 1x USB Cable
