Difference between revisions of "Sensor / Trinket Template"
From Microduino Wiki
(→Microduino Series) |
(→mCookie Series) |
||
| Line 33: | Line 33: | ||
==mCookie Series== | ==mCookie Series== | ||
| + | *1x of the following core module: | ||
| + | **mCookie Core | ||
| + | **mCookie Core+ | ||
| + | **mCookie CoreUSB | ||
| + | **mCookie CoreRF | ||
| + | *1x of the following core programmers: | ||
| + | **mCookie USB-TTL | ||
| + | **mCookie mBattery (built-in programmer) | ||
| + | *1x mCookie Connector Hub | ||
| + | *1x Connector Wire | ||
| + | *1x USB Cable | ||
Revision as of 22:47, 31 January 2019
Contents
Introduction
The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.
Technical Specifications
- SKU / module number: MSDS11
- Operating voltage: 5V
- Connectors: n/a
- Chip Used: n/a
- Schematics: File:Na
- Dimensions:
Compatible Pins
Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.
This module requires a digital input compatible pin as shown below:
Hardware Setup
The bare minimum hardware configurations to used this module is as follows:
Microduino Series
- 1x of the following core module:
- Microduino Core
- Microduino Core+
- Microduino CoreUSB
- Microduino CoreRF
- 1x Microduino USBTTL
- 1x Microduino Connector Hub
- 1x Connector Wire
- 1x USB Cable
mCookie Series
- 1x of the following core module:
- mCookie Core
- mCookie Core+
- mCookie CoreUSB
- mCookie CoreRF
- 1x of the following core programmers:
- mCookie USB-TTL
- mCookie mBattery (built-in programmer)
- 1x mCookie Connector Hub
- 1x Connector Wire
- 1x USB Cable
