Difference between revisions of "Sensor / Trinket Template"
From Microduino Wiki
(→mCookie Series) |
(→mCookie Series (using mCenter)) |
||
| Line 40: | Line 40: | ||
*'''1x Crash Sensor''' | *'''1x Crash Sensor''' | ||
| − | ==mCookie Series (using mCenter)== | + | ==mCookie Series (using mCenter+)== |
*1x mCenter+ (built-in mCookie Core+ & programmer) | *1x mCenter+ (built-in mCookie Core+ & programmer) | ||
*1x Connector Wire | *1x Connector Wire | ||
*1x USB Cabvle | *1x USB Cabvle | ||
*'''1x Crash Sensor''' | *'''1x Crash Sensor''' | ||
Revision as of 22:50, 31 January 2019
Contents
Introduction
The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.
Technical Specifications
- SKU / module number: MSDS11
- Operating voltage: 5V
- Connectors: n/a
- Chip Used: n/a
- Schematics: File:Na
- Dimensions:
Compatible Pins
Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.
This module requires a digital input compatible pin as shown below:
Hardware Setup
The bare minimum hardware configurations to used this module is as follows:
Microduino Series
- 1x of the following core module:
- Microduino Core
- Microduino Core+
- Microduino CoreUSB
- Microduino CoreRF
- 1x Microduino USBTTL
- 1x Microduino Connector Hub
- 1x Connector Wire
- 1x USB Cable
mCookie Series
- 1x of the following core module:, mCookie Core, mCookie Core+, mCookie CoreUSB, or mCookie CoreRF
- 1x of the following core programmers: mCookie USB-TTL, or mCookie mBattery (built-in programmer)
- 1x mCookie Connector Hub
- 1x Connector Wire
- 1x USB Cable
- 1x Crash Sensor
mCookie Series (using mCenter+)
- 1x mCenter+ (built-in mCookie Core+ & programmer)
- 1x Connector Wire
- 1x USB Cabvle
- 1x Crash Sensor
