Difference between revisions of "Sensor / Trinket Template"
From Microduino Wiki
(→Hardware Setup) |
(→mCookie Series) |
||
| Line 29: | Line 29: | ||
==mCookie Series== | ==mCookie Series== | ||
| − | *1x of the following core module: | + | *1x of the following core module:mCookie Core, mCookie Core+, mCookie CoreUSB, or mCookie CoreRF |
*1x of the following core programmers: mCookie USB-TTL, or mCookie mBattery (built-in programmer) | *1x of the following core programmers: mCookie USB-TTL, or mCookie mBattery (built-in programmer) | ||
*1x mCookie Connector Hub | *1x mCookie Connector Hub | ||
Revision as of 22:52, 31 January 2019
Contents
Introduction
The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.
Technical Specifications
- SKU / module number: MSDS11
- Operating voltage: 5V
- Connectors: n/a
- Chip Used: n/a
- Schematics: File:Na
- Dimensions:
Compatible Pins
Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.
This module requires a digital input compatible pin as shown below:
Hardware Setup
The bare minimum hardware configurations to used this module is as follows:
Microduino Series
- 1x of the following core module: Microduino Core, Microduino Core+, Microduino CoreUSB, or Microduino CoreRF
- 1x Microduino USBTTL
- 1x Microduino Connector Hub
- 1x Connector Wire
- 1x Crash Sensor
mCookie Series
- 1x of the following core module:mCookie Core, mCookie Core+, mCookie CoreUSB, or mCookie CoreRF
- 1x of the following core programmers: mCookie USB-TTL, or mCookie mBattery (built-in programmer)
- 1x mCookie Connector Hub
- 1x Connector Wire
- 1x Crash Sensor
mCookie Series (using mCenter+)
- 1x mCenter+ (built-in mCookie Core+ & programmer)
- 1x Connector Wire
- 1x Crash Sensor
