Difference between revisions of "Sensor / Trinket Template"
From Microduino Wiki
(→Hardware Setup) |
|||
| Line 23: | Line 23: | ||
==Microduino Series== | ==Microduino Series== | ||
<tab name="View" collapsed> | <tab name="View" collapsed> | ||
| + | [[File:Microduino_Crash-rect.jpg|thumb|right]] | ||
*1x of the following core modules: Microduino Core, Microduino Core+, Microduino CoreUSB, or Microduino CoreRF | *1x of the following core modules: Microduino Core, Microduino Core+, Microduino CoreUSB, or Microduino CoreRF | ||
*1x Microduino USBTTL | *1x Microduino USBTTL | ||
| Line 32: | Line 33: | ||
==mCookie Series== | ==mCookie Series== | ||
<tab name="View" collapsed> | <tab name="View" collapsed> | ||
| + | [[File:Microduino_Crash-rect.jpg|thumb|right]] | ||
*1x of the following core modules: mCookie Core, mCookie Core+, mCookie CoreUSB, or mCookie CoreRF | *1x of the following core modules: mCookie Core, mCookie Core+, mCookie CoreUSB, or mCookie CoreRF | ||
*1x of the following core programmers: mCookie USB-TTL, or mCookie mBattery (built-in programmer) | *1x of the following core programmers: mCookie USB-TTL, or mCookie mBattery (built-in programmer) | ||
| Line 41: | Line 43: | ||
==mCookie Series (using mCenter+)== | ==mCookie Series (using mCenter+)== | ||
<tab name="View" collapsed> | <tab name="View" collapsed> | ||
| + | [[File:Microduino_Crash-rect.jpg|thumb|right]] | ||
*1x mCenter+ (built-in mCookie Core+ & programmer) | *1x mCenter+ (built-in mCookie Core+ & programmer) | ||
*1x Connector Wire | *1x Connector Wire | ||
*'''1x Crash Sensor''' | *'''1x Crash Sensor''' | ||
</tab> | </tab> | ||
Revision as of 23:07, 31 January 2019
Contents
Introduction
The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.
Technical Specifications
- SKU / module number: MSDS11
- Operating voltage: 5V
- Connectors: n/a
- Chip Used: n/a
- Schematics: File:Na
- Dimensions:
Compatible Pins
Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.
This module requires a digital input compatible pin as shown below:
Hardware Setup
The bare minimum hardware configurations to used this module is as follows:
