Difference between revisions of "Sensor / Trinket Template"
From Microduino Wiki
(→mCookie Series) |
(→mCookie Series (using mCenter+)) |
||
| Line 42: | Line 42: | ||
==mCookie Series (using mCenter+)== | ==mCookie Series (using mCenter+)== | ||
| − | <tab name="View" collapsed> | + | <tab name="View" style="width:100%" collapsed> |
[[File:Microduino_Crash-rect.jpg|thumb|right]] | [[File:Microduino_Crash-rect.jpg|thumb|right]] | ||
*1x mCenter+ (built-in mCookie Core+ & programmer) | *1x mCenter+ (built-in mCookie Core+ & programmer) | ||
Revision as of 23:08, 31 January 2019
Contents
Introduction
The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.
Technical Specifications
- SKU / module number: MSDS11
- Operating voltage: 5V
- Connectors: n/a
- Chip Used: n/a
- Schematics: File:Na
- Dimensions:
Compatible Pins
Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.
This module requires a digital input compatible pin as shown below:
Hardware Setup
The bare minimum hardware configurations to used this module is as follows:
