Difference between revisions of "Sensor / Trinket Template"
From Microduino Wiki
(→Digital Read) |
(→Digital Read) |
||
Line 57: | Line 57: | ||
{|style="border-down:10px;border-right:10px" | {|style="border-down:10px;border-right:10px" | ||
− | |'''Description: | + | |'''Description:``''' |
|Reads the current value of the Crash Sensor. | |Reads the current value of the Crash Sensor. | ||
|- | |- |
Revision as of 20:35, 22 February 2019
Contents
Introduction
The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.
Technical Specifications
- SKU / module number: MSDS11
- Operating voltage: 5V
- Connectors: n/a
- Chip Used: n/a
- Schematics: File:Na
- Dimensions:
Compatible Pins
Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.
This module requires a digital input compatible pin as shown below:
Hardware Setup
The bare minimum hardware configurations to used this module is as follows:
Microduino Series
mCookie Series
mCookie Series (using mCenter+)
Usage
Arduino IDE
Digital Read
digitalRead(pinNum)
Description:`` | Reads the current value of the Crash Sensor. |
Arguments: | pinNum - the pin number that the Crash Sensor is connected to. |
Return: | true or high when the Crash Sensor is NOT pressed. |
false or low when the Crash Sensor is pressed. |