Difference between revisions of "Microduino GPS recorder-306KIT"
(→Outline) |
|||
| Line 6: | Line 6: | ||
Project：Microduino GPS Recorder | Project：Microduino GPS Recorder | ||
| − | + | Objective：Adopt the Microduino GPS module to acquire the geographic information and store it into Microduino-SD. | |
Difficulty：Elementary | Difficulty：Elementary | ||
| Line 15: | Line 15: | ||
|- | |- | ||
| | | | ||
| + | |||
==Bill of Materials== | ==Bill of Materials== | ||
*Microduino module：（MICRODUINO 203KIT） | *Microduino module：（MICRODUINO 203KIT） | ||
Revision as of 07:03, 26 August 2014
| Language: | English • 中文 |
|---|
OutlineProject：Microduino GPS Recorder Objective：Adopt the Microduino GPS module to acquire the geographic information and store it into Microduino-SD. Difficulty：Elementary Time-consuming：2 hours Maker：Microduino Studio-YLB | ||||||||||||||||||
Bill of Materials
| ||||||||||||||||||
Document | ||||||||||||||||||
DebugStep 1：Set up hardware Stack all the modules, and put the GPS antenna to outside, or may not receive the signal. | ||||||||||||||||||
|
Step 2：Download program If use the default jumper (RX0、TX1), need unplug the Microduino NEO-6M when download program； Step 3：Test Find an open area to test, can't in the room, because no signal is received. The current status of the module can be judged by the PPS indicator: lighting, indicates that the module has started to work, but hasn't achieved position informaton. Flashing (100ms off, 900ms bright), which means that the module has been successful positioning. | ||||||||||||||||||
ResultAfter get the position information, the parameters can be seen, and these data can be recorded into the memory card.
| ||||||||||||||||||
Note
Video |
