Difference between revisions of "MCookie-Motion"

mCookie-Motion module integrates three sensors including a three-axis accelerometer+ three-axis gyroscope (MPU6050) and a digital barometer sensor(BMP180), which adopts I3C interface and connects with the core modules. It can be widely used in projects such as model airplane and self-balance robot.

==Features

• All sensors communicate with I2C , which can save IO port and can be widely used.

*Small, stackable, open and cheap; 

• Easy to be integrated to pegboards with 2.54-pitch female header connector interface.

Specification

Digital Barometer Sensor: BMP180

• BMP180 includes a resistance-type pressure sensor, an AD converter and a control unit.
  • Control unit contains E2PROM and I2C interface. For E2PROM, it saves 176-bit separate standard data and these data are used for adding parameters of temperature dependency and sensors.
• Distance range: 300hPa-1100hPa (Correspond to altitude from -500m to +9000m)
• Absolute accuracy can reach 0.03hPa to the lowest.
• UP=Universal pressure data(16 to 19bit)
• UT=Universal temperature data(0 to 15bit)

MPU6050

• It integrates a three-axis MEMS gyroscope and accelerator as well as an extensible Digital Motion Processer (DMP);
• Output fusion data of the 6-axis or 9-axis rotation matrix, Aaternion and EulerAngleforma;
• Own accuracy of 131LSBs/°/sec and full-lattice sensing range including ±250, ±500, ±1000 and ±2000°/sec;
• Programmable control: The program control range is±2g, ±4g, ±8g and ±16;
• Remove sensitivity between accelerator and gyroscope; Reduce sensor drift and effects brought by settings.
• DMP engine can reduce burden brought by complicated fusion data, sensing device synchronization and altitude induction.
• Temperature sensor with digital output;
• Operation current for gyroscope: 5mA; Standby current for gyroscope: 5uA; Operation current for accelerator: 500uA; Accelerator current under power saving mode: 40uA @ 10Hz up to 400kHz fast mode of IIC.

Document

Main Components

• MPU6050 File:PS-MPU-6000A-00v3.4.pdf
• BMP180 File:BMP180 en.pdf

Development

For the development, it need to be supported by _05_Microduino_10DOF library and check the library file here: (Installation Address)\Microduino-IDE\hardware\Microduino\avr\libraries

Project

Test MPU6050 Altitude Sensor

Test BMP180 Air-pressure Sensor

• Open the " BMP085_basic " program of

file->examples->_05_Microduino_10DOF->sensor_BMP085.

• Download program to the core module, open the serial monitor and you'll see data about temperature, air-pressure and altitude.

F&Q

• How to run 10DOF test program on Mac?
  • Install Arduino IDE 1.0.5 on Mac Osx10.9. as well as Microduino hardware support package:(http://www.microduino.cc/wiki/index.php?title=Arduino_IDE_Microduino)
  • Download 10DOF test program:

http://www.microduino.cc/wiki/index.php?title=Microduino-10DOF

• • Change according to following link and then download program to the core module. MicroduinoCommunities

Purchase

History

Pictures