Difference between revisions of "Mixly Block Category - Sensor"
From Microduino Wiki
(→Get Temperature/Humidity from DHT11) |
(→Get Temperature from DS18B20) |
||
| Line 22: | Line 22: | ||
*Pin # - The pin number that the DHT11 is attached to. | *Pin # - The pin number that the DHT11 is attached to. | ||
| − | =Get Temperature | + | =DS18B20= |
| + | ==Get Temperature== | ||
| + | Get | ||
| + | |||
=Initialize GPS= | =Initialize GPS= | ||
=Read and Print GPS Data= | =Read and Print GPS Data= | ||
Revision as of 01:52, 23 February 2017
Contents
Ultrasonic Sensor
An Ultrasonic Sensor uses ultrasonic sound to detect the range of an object in which the sound wave is directed towards.
Read more here: http://randomnerdtutorials.com/complete-guide-for-ultrasonic-sensor-hc-sr04/
Read Range (cm)
This block returns the distance in centimeters (cm) that the Ultrasonic Sensor detects a object to be.
- Trigger Pin - Is the pin used to activate the ultrasonic ping on the sensor.
- Echo Pin - Is the pin which detects / returns the result of the ultrasonic ping. Basically, the distance detected.
DHT11
The DHT11 is a sensor used to measure temperature and humidity.
Read more here: http://playground.arduino.cc/Main/DHTLib
Get Temperature
Returns the temperature (in ?) detected by the DHT11 sensor.
- Pin # - The pin number that the DHT11 is attached to.
Get Humidity
Returns the humidity (in ?) detected by the DHT11 sensor.
- Pin # - The pin number that the DHT11 is attached to.
DS18B20
Get Temperature
Get
