Difference between revisions of "Sensor / Trinket Template"
From Microduino Wiki
(→Hardware Setup) |
|||
| Line 20: | Line 20: | ||
=Hardware Setup= | =Hardware Setup= | ||
| − | The bare minimum hardware configurations to used this module is as follows | + | The bare minimum hardware configurations to used this module is as follows: |
==Microduino Series== | ==Microduino Series== | ||
*1x a Microduino core module (Core, Core+, CoreUSB, CoreRF) | *1x a Microduino core module (Core, Core+, CoreUSB, CoreRF) | ||
Revision as of 22:43, 31 January 2019
Contents
Introduction
The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.
Technical Specifications
- SKU / module number: MSDS11
- Operating voltage: 5V
- Connectors: n/a
- Chip Used: n/a
- Schematics: File:Na
- Dimensions:
Compatible Pins
Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.
This module requires a digital input compatible pin as shown below:
Hardware Setup
The bare minimum hardware configurations to used this module is as follows:
Microduino Series
- 1x a Microduino core module (Core, Core+, CoreUSB, CoreRF)
- 1x Microduino USBTTL
- 1x Microduino Connector Hub
- 1x Connector Wire
- 1x USB Cable
