Difference between revisions of "Sensor / Trinket Template"
From Microduino Wiki
(→Hardware Setup) |
(→Microduino Series) |
||
| Line 22: | Line 22: | ||
The bare minimum hardware configurations to used this module is as follows: | The bare minimum hardware configurations to used this module is as follows: | ||
==Microduino Series== | ==Microduino Series== | ||
| − | *1x | + | *1x of the following core module: |
| + | **Microduino Core | ||
| + | **Microduino Core+ | ||
| + | **Microduino CoreUSB | ||
| + | **Microduino CoreRF | ||
*1x Microduino USBTTL | *1x Microduino USBTTL | ||
*1x Microduino Connector Hub | *1x Microduino Connector Hub | ||
*1x Connector Wire | *1x Connector Wire | ||
*1x USB Cable | *1x USB Cable | ||
| + | |||
==mCookie Series== | ==mCookie Series== | ||
Revision as of 22:45, 31 January 2019
Contents
Introduction
The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.
Technical Specifications
- SKU / module number: MSDS11
- Operating voltage: 5V
- Connectors: n/a
- Chip Used: n/a
- Schematics: File:Na
- Dimensions:
Compatible Pins
Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.
This module requires a digital input compatible pin as shown below:
Hardware Setup
The bare minimum hardware configurations to used this module is as follows:
Microduino Series
- 1x of the following core module:
- Microduino Core
- Microduino Core+
- Microduino CoreUSB
- Microduino CoreRF
- 1x Microduino USBTTL
- 1x Microduino Connector Hub
- 1x Connector Wire
- 1x USB Cable
