Difference between revisions of "Microduino-Module Audio"
From Microduino Wiki
(→Features) |
(→Development) |
||
Line 41: | Line 41: | ||
==Development== | ==Development== | ||
*Dial wheel button control | *Dial wheel button control | ||
− | **Hardware needed: [Microduino-Core+]], [[Microduino-USBTTL]],[[Microduino-Amplifier]], Microduino-Audio, Audio-KEY-SD, two loudspeakers and power supply (1A or higher) or [[Microduino Extension Boards | + | **Hardware needed: [Microduino-Core+]], [[Microduino-USBTTL]],[[Microduino-Amplifier]], Microduino-Audio, Audio-KEY-SD, two loudspeakers and power supply (1A or higher) or [[Microduino Extension Boards]]; |
**Connect your PC with Microduino-Audio and write audio file into flash, which can refer to document instructure; | **Connect your PC with Microduino-Audio and write audio file into flash, which can refer to document instructure; | ||
**Stack Audio-KEY-SD. Meantime, Microduino-Audio’s microUSB interface is not directly connected with the computer. You need to change another power supply so as not to recognize the driver and fail to play music. Please make sure the current should be 1A or higher, otherwise, it may cause music play failure due to undercurrent. Or you can use microUSB on Microduino extension module to supply power. | **Stack Audio-KEY-SD. Meantime, Microduino-Audio’s microUSB interface is not directly connected with the computer. You need to change another power supply so as not to recognize the driver and fail to play music. Please make sure the current should be 1A or higher, otherwise, it may cause music play failure due to undercurrent. Or you can use microUSB on Microduino extension module to supply power. |
Revision as of 03:54, 7 December 2015
Language: | English • 中文 |
---|
Microduino-Audio is the audio play module based on JQ6500 serial port MP3 chip, which together with Audio-KEY-SD can play flash music by thumbwheel switch control and with Microduino core module can send serial port commands to control the system.
ContentsFeatures
Specification
DocumentJQ6500 sound chip description: File:JQ6500.pdf Development
Program description: "arduino.h" is audio control file. 1. Under default serial port, you can select serial port in "arduino.h" based on your core module. #define AUDIO_PORT Serial1 //Core+
//#define AUDIO_PORT mySerial //Core 2. Initialize Audio module and you can choose where to start the music. #define DEVICE_Flash 5
#define DEVICE_TF 1 If you want to play Flash, please initialize: audio_init(DEVICE_Flash,MODE_loopOne,music_vol); 3. Initialize Audio module and choose play mode. #define MODE_loopAll 0
#define MODE_loopOne 1
#define MODE_One_STOP 2
#define MODE_One_END 4
ApplicationMicroduino-Audio is widely used in various kinds of voice broadcast:
PurchaseHistoryPictureFrontBackVideo |