The product number of Sensor-Buzzer is: MSDO11
Sensor-Buzzer is a passive buzzer. Like a magnetic speaker, it needs voltage with different frequency so that it can make sound accordingly. The pitch becomes louder when the frequency gets higher.
Introduction of Pins
|
- Pins of the sensor:
- PIN1: GND
- PIN2: VCC
- General signal pins:
- PIN3(IO1): digital/analog signal
- PIN4(IO2): NC(null)
- Special signal pins:
- If it is IIC: IO1/IO2 are respectively SDA/SCL.
- If it is soft serial port: IO1/IO2 are respectively tx/rx.
|
Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub.
|
Features
- Controllable sound frequency (eg: You can achieve the effect of piano spectrum with it. )
- Small size which is easy to install.
Specification
- Size
- Size of the board: 23.5mm*13mm
- 1.27mm-spacing 4Pin interface connected with sensorhub.
- The CAD drawing of the sensor: File:Sensor CAD.zip
- Technical parameters
- Drive with 2K~5K square wave
- The sound frequency is controllable.
- Connection
- This sensor can be connected to the following interfaces of core: A0~A7,D2~D13
Document
Development
Program Download
Programming
Hardware Setup
- Referring to the following diagram, connect the Sensor-Buzzer to digital pin D6 of Microduino-Sensorhub.
Result
- After download, you can hear the alarming sound.
Application
The buzzer can produce many weird sound. Maybe you can add some keys to it to compose a piece of wonderful music.
Projects
Purchase
History
Gallery
|