Sensor / Trinket Template

Introduction

The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.

Technical Specifications

• SKU / module number: MSDS11
• Operating voltage: 5V
• Connectors: n/a
• Chip Used: n/a
• Schematics: File:Na
• Dimensions:

Compatible Pins

Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.

This module requires a digital input compatible pin as shown below:

image of compatible pins

Hardware Setup

The bare minimum hardware configurations to used this module is as follows:

Microduino Series

• 1x of the following core module:
  • Microduino Core
  • Microduino Core+
  • Microduino CoreUSB
  • Microduino CoreRF
• 1x Microduino USBTTL
• 1x Microduino Connector Hub
• 1x Connector Wire
• 1x USB Cable