Mixly Block Category - Ethernet
Allow an Arduino / Microduino board to connect to the internet.
Read more here: https://www.arduino.cc/en/Reference/Ethernet
Contents
Begin Ethernet
Initializes the ethernet library and network settings.
Read more here: https://www.arduino.cc/en/Reference/EthernetBegin
localIP
Returns the IP of this device once connected to the network. Can be used to determine the IP of the device.
Read more here: https://www.arduino.cc/en/Reference/EthernetLocalIP
Connect to Host
Connects to a specified IP address and port. The return value indicates success or failure. Also supports DNS lookups when using a domain name.
Read more here: https://www.arduino.cc/en/Reference/ClientConnect
Connected
Returns whether or not the client is connected. Note that a client is considered connected if the connection has been closed but there is still unread data.
Read more here: https://www.arduino.cc/en/Reference/ClientConnected
Available Data
Returns the number of bytes available for reading (that is, the amount of data that has been written to the client by the server it is connected to).
Read more here: https://www.arduino.cc/en/Reference/ClientAvailable
Read
Read the next byte received from the server the client is connected to (after the last call to read).
Read more here: https://www.arduino.cc/en/Reference/ClientRead
Stop
Disconnect from the server.
Read more here: https://www.arduino.cc/en/Reference/ClientStop
Without Newline
Print data to the server that a client is connected to. Prints numbers as a sequence of digits, each an ASCII character (e.g. the number 123 is sent as the three characters '1', '2', '3').
Read more here: https://www.arduino.cc/en/Reference/ClientPrint
With Newline
Print data, followed by a carriage return and newline, to the server a client is connected to. Prints numbers as a sequence of digits, each an ASCII character (e.g. the number 123 is sent as the three characters '1', '2', '3').
Read more here: https://www.arduino.cc/en/Reference/ClientPrintln
