Mixly Block Category - Actuator

From Microduino Wiki
Revision as of 22:12, 23 February 2017 by Sonny (talk) (Servo)
Jump to: navigation, search

Servo

Servos have integrated gears and a shaft that can be precisely controlled. Standard servos allow the shaft to be positioned at various angles, usually between 0 and 180 degrees. Continuous rotation servos allow the rotation of the shaft to be set to various speeds.


Read more here: https://www.arduino.cc/en/Reference/Servo

Set Position in Degrees with Delay

Writes a value to the servo, controlling the shaft accordingly. On a standard servo, this will set the angle of the shaft (in degrees), moving the shaft to that orientation. On a continuous rotation servo, this will set the speed of the servo (with 0 being full-speed in one direction, 180 being full speed in the other, and a value near 90 being no movement). A configurable delay time is added after calling the servo to move to allow to the requested angle.

  • Servo Pin # - The pin number that the servo is connected to.
  • Degree (0~180) - The angle to move the servo shaft to.
  • Delay (ms) - A delay in milliseconds after requesting the servo to move. This allows the servo physically move the servo shaft to the request angle.


Read more here: https://www.arduino.cc/en/Reference/ServoWrite

Set Position in Microseconds (PWM)

Writes a value in microseconds (uS) to the servo, controlling the shaft accordingly. On a standard servo, this will set the angle of the shaft. On standard servos a parameter value of 1000 is fully counter-clockwise, 2000 is fully clockwise, and 1500 is in the middle.

  • Servo Pin # - The pin number that the servo is connected to.
  • Microseconds - Set the direct PWM value (instead of an angle) that is sent to the Servo.


Read more here: https://www.arduino.cc/en/Reference/ServoWriteMicroseconds

Read Position

Returns the current angle of the servo (the value passed to the last call to Set Position in Degrees).

  • Servo Pin # - The pin number that the servo is connected to.


Read more here: https://www.arduino.cc/en/Reference/ServoRead

Tone

Output Tone with Frequency

  • Without Delay
  • With Delay

Stop Output Tone

LED

Setup

Print String

  • Line
  • Row / Column

Clear

Stepper Motor

Setup

  • 2 Pin
  • 4 Pin

Step