Template:Setup mBattery with Core (Mac)

From Microduino Wiki
Revision as of 18:07, 5 March 2018 by Sonny (talk | contribs)
Jump to: navigation, search
  1. Open the Microduino software.
    ArduinoIcon.png

  2. Go to “Tools > Board” and select “Microduino/mCookie-device”
    Mac - Board Selection Cropped.png

  3. Go to “Tools > Processor” and select “Microduino/mCookie-Core (328p)@16M,5V”
    Mac - Select Processor Cropped.png

  4. Only have the red Core module and yellow battery stacked. Then connect the MicroUSB to the yellow battery and the other end to your computer's USB port.
    MBattery-b.jpg

  5. Check if the red LED is lit on the yellow battery. This indicates the battery is ON and SUPPLYING power to the modules.
    If there is no red LED lit, then press and hold the button on the yellow battery for a few seconds to turn it on.
    Note: Blinking blue LEDs indicates the battery is CHARGING ONLY. 
    IMPORTANT: The red LED must be on when programming or using your project.
    MBattery-t.jpg

  6. Go to “Tools > Port” and select the port. It is usually the one that is select-able. (it is not the Bluetooth one)
    Mac - Select Serial Port Cropped.png

  7. With the default sample code. Hit upload (right arrow icon on the top left of the software).
    Mac - Upload Button Cropped.png

  8. The code will compile and will say upload complete if successful. Congratulations the software setup is complete!
    Mac - Upload complete Cropped.png

Retrieved from "https://wiki.microduinoinc.com/index.php?title=Template:Setup_mBattery_with_Core_(Mac)&oldid=21817"