Getting Started with Itty Bitty City (Windows)

From Microduino Wiki
Revision as of 16:07, 12 March 2018 by Sonny (talk | contribs) (Projects)
Jump to: navigation, search

Download and Install Software

Note: If you have a previous version installed already, you must uninstall that version prior to installing a newer version.
  • Go to Control Panel and uninstall the Arduino IDE for Microduino.
  • Delete the C:\Program Files (x86)\Arduino IDE for Microduino folder as some legacy files may cause issues with a new installation.

Then proceed to the next steps.

1. Download the latest Windows IDE (Version 5.0, 2019-03-25): HERE

Arduino Download.png

2. Double click on the setup file to start the installation process. Click Next.

WinInstallNew 01.png

3. The next window will allow you to select which options to install. Leave all checked and click Install.

WinInstallNew 02.png

4. The installation process will begin for the Arduino IDE.

WinInstallNew 03.png

5. Wait until it is complete.

WinInstallNew 04.png

6. After the Arduino IDE has been installed, a window for driver installation will appear. Click Next.

WinInstallNew 05.png

7. Click on "I accept this agreement" and click Next to start the drivers installation.

WinInstallNew 06.png

8. After the drivers are installed, click Finish.

WinInstallNew 07.png

9.Installation is now complete! Click on Finish.

WinInstallNew 08.png

10.If you left the run option checked, the software will start to launch. Otherwise locate the program shortcut on your desktop or start menu and launch it.

WinInstallNew 09.png

11. The software is now ready to be used!

WinInstallNew 10.png

Configuring and Testing the Software/Hardware

  1. Open the Microduino software.
    ArduinoIcon.png

  2. Go to “Tools > Board” and select “Microduino/mCookie-device”
    Software Setup Guide Select Board.png

  3. Go to “Tools > Processor” and select “Microduino/mCookie-Core (328p)@16M,5V”
    Software Setup Guide Select Processor.png

  4. Only have the red Core module and yellow battery stacked. Then connect the MicroUSB to the yellow battery and the other end to your computer's USB port.
    MBattery-b.jpg

  5. Check if the red LED is lit on the yellow battery. This indicates the battery is ON and SUPPLYING power to the modules.
    If there is no red LED lit, then press and hold the button on the yellow battery for a few seconds to turn it on.
    Note: Blinking blue LEDs indicates the battery is CHARGING ONLY.
    IMPORTANT: The red LED must be on when programming or using your project.
    MBattery-t.jpg

  6. Go to “Tools > Port” and select the port. It is usually the one that is select-able.
    Software Setup Guide Select Port Selection.png

  7. With the default sample code. Hit upload (right arrow icon on the top left of the software).
    Software Setup Guide Select Upload.png

  8. The code will compile and will say upload complete if successful. Congratulations the software setup is complete!
    Software Setup Guide Select Done Upload.png

The Itty Bitty City Projects can be found under File > Examples > 00.mCookie_IBC
Software Setup Guide Select IBC Projects.png


Projects

Follow the printed manual to build and program Itty Bitty City's projects.


Download the digital version of the printed manual:
IBC Manual.png