Single Color LED (use with mDesigner)
From Microduino Wiki
The Single Color LED is a light emitting diode (LED), which is capable of emitting a illuminating a single color. Red, green and yellow are the common colors. Support for this trinket is found in mDesigner.
Compatible Pins
The following pins on the Hub or mCenter+'s Hub support this module:
Hub
| Pin Name | Compatibility | Notes |
|---|---|---|
| Pin 0 | Yes | Not recommended, since Pin 0 & 1 are used by mDesigner (serial communication). |
| Pin 1 | Yes | Not recommended, since Pin 0 & 1 are used by mDesigner (serial communication). |
Blocks
The follow blocks are used for this module.
Set Pin
This block sets the voltage level on the selected pin either to high or low.
- When set to high, the Single Color LED turns on (illuminates).
- When set to low, the Single Color LED turns off (no illumination).
Examples
Set Pin PWM
This block sets the voltage level on the selected pin varying values. Values between 0 and 255 will cause the Single Color LED to turn on at different levels.
- When set to 255, the Single Color LED is at maximum on.
- When set to 0, the Single COlor LED is off.
- When set to 127, the Single Color LED is half-way on.
- Other values between 0 and 255 will turn on the LED at appropriate brightness levels.
*Note: Only pins which support "Analog Write" will work correctly with this block.
- For Microduino / mCookie Core: Pins A, B, C
- For Microduino / mCookie Core+, mCenter+: Pins D, E, F
