Single Color LED (use with mDesigner)

The Single Color LED is a light emitting diode (LED), which is capable of emitting a illuminating a single color. Red, green and yellow are the common colors. Support for this trinket is found in mDesigner.

Compatible Pins

The following pins on the Hub or mCenter+'s Hub support this module:

Hub

Pin Name	Compatibility	Notes
Pin 0	Yes	Not recommended, since Pin 0 & 1 are used by mDesigner (serial communication).
Pin 1	Yes	Not recommended, since Pin 0 & 1 are used by mDesigner (serial communication).

Blocks

Set Pin

This block sets the voltage level on the selected pin either to high or low.

• When set to high, the Single Color LED turns on (illuminates).
• When set to low, the Single Color LED turns off (no illumination).

• Pin Number - the pin to configure the state of.
• State - set the pin to "high" or "low" state.

Examples Uses

Software Setup for Examples

• Setup your software for either Live Mode or Arduino Mode.

Hardware Setup for Examples [[]]

• Example 1: Turn off the Single Color LED connected to pin 6.

• Example 2: Turn on the Single Color LED connected to pin 6.

• Example 3: Turn on the Single Color LED connected to pin 6, wait 1 second, then turn off, wait another second, then loop repeatedly.

Set Pin PWM

This block sets the voltage level on the selected pin varying values. Values between 0 and 255 will cause the Single Color LED to turn on at different levels.

• When set to 255, the Single Color LED is at maximum on.
• When set to 0, the Single COlor LED is off.
• When set to 127, the Single Color LED is half-way on.
• Other values between 0 and 255 will turn on the LED at appropriate brightness levels.

Note: Only pins which support "Analog Write" will work correctly with this block. *For Microduino / mCookie Core: Pins 3, 5, 6, 9, 10, and 11 *For Microduino / mCookie Core+, mCenter+: Pins 7, 8, 9, 10, 12, 13, 22, and 23

• Pin Number - the pin to configure the state of. Note: Only certain pins support this ability. See above for which pins has this ability in your hardware setup.
• Value - the value between 0 and 255 to set the pin to.

Examples Uses

Software Setup for Examples

• Setup your software for either Live Mode or Arduino Mode.

Hardware Setup for Examples [[]]

• Example 1: Turn off the Single Color LED connected to pin 6. (Note: Change the pin number to one that supports this block, see yellow box above)

• Example 2: Fully turn on the Single Color LED connected to pin 6. (Note: Change the pin number to one that supports this block, see yellow box above)

• Example 3: Turn the Single Color LED half way on (127 out of 255 ~= 0.5) connected to pin 6. (Note: Change the pin number to one that supports this block, see yellow box above)

• Example 3: Turn the Single Color LED connected to pin 6 full on (255), wait 1 second, then set half way on (127), wait another second, then loop repeatedly. (Note: Change the pin number to one that supports this block, see yellow box above)