Itty Bitty Buggy: Motors Tutorial (mDesigner)

From Microduino Wiki
Revision as of 19:02, 30 October 2018 by Sonny (talk | contribs) (Created page with "=Motors= '''Motor''' blocks are blocks which controls the motors on Buggy Base directly. This gives the user the ability to fine tune the behavior of the motors. The motors ar...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Motors

Motor blocks are blocks which controls the motors on Buggy Base directly. This gives the user the ability to fine tune the behavior of the motors. The motors are referenced as Motor "A" or "B" depending on the side it resides. These blocks can set the movement direction of the motors (Motor - Set Speed block) or brake / stop the motors (Motor - Stop block).

Block: Set Speed

The motors speed and direction can be controlled with the Motor - Set Speed block.

Note: This block is NOT holding. Which means once the motor's speed is set, then the program will go to the next block immediately. The motor will continue to run.

Function: This block sets the speed of the selected motor.

IBB mDesigner Motor Block Set Speed.png
  • Motor - select motor (either A, B, or AB (both)).
  • Speed - rate to set the selected Motor. A value between -255 and 255. Negative values will spin the motor in reverse.
  • 0 being off
  • 127 being half speed forward.
  • 255 being full speed forward
  • -255 being full speed backward
  • -127 being half speed backward

Block: Stop

The motors can be stopped with the Motor - Stop block.

Function: This block stops the selected motor.

IBB mDesigner Motor Block Stop.png
  • Motor - select motor to stop (either A, B, or AB (both)).
Retrieved from "https://wiki.microduinoinc.com/index.php?title=Itty_Bitty_Buggy:_Motors_Tutorial_(mDesigner)&oldid=23147"