Sensor / Trinket Template

Introduction

The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.

Technical Specifications

• SKU / module number: MSDS11
• Operating voltage: 5V
• Connectors: n/a
• Chip Used: n/a
• Schematics: File:Na
• Dimensions:

Compatible Pins

Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.

This module requires a digital input compatible pin as shown below:

image of compatible pins

Hardware Setup

The bare minimum hardware configurations to used this module is as follows:

Microduino Series

ViewView

• 1x of the following core modules: Microduino Core, Microduino Core+, Microduino CoreUSB, or Microduino CoreRF
• 1x Microduino USBTTL
• 1x Microduino Connector Hub
• 1x Connector Wire
• 1x Crash Sensor

mCookie Series

ViewView

• 1x of the following core modules: mCookie Core, mCookie Core+, mCookie CoreUSB, or mCookie CoreRF
• 1x of the following core programmers: mCookie USB-TTL, or mCookie mBattery (built-in programmer)
• 1x mCookie Connector Hub
• 1x Connector Wire
• 1x Crash Sensor

mCookie Series (using mCenter+)

ViewView

• 1x mCenter+ (built-in mCookie Core+ & programmer)
• 1x Connector Wire
• 1x Crash Sensor

Usage

Arduino IDE

Digital Read

digitalRead(pinNum)

Description:<t>	Reads the current value of the Crash Sensor.
Arguments:	pinNum - the pin number that the Crash Sensor is connected to.
Return:	true or high when the Crash Sensor is NOT pressed.
	false or low when the Crash Sensor is pressed.