Template:Setup mBattery with Core (Windows)

From Microduino Wiki
Jump to: navigation, search
  1. Open the Microduino software.
    ArduinoIcon.png

  2. Go to “Tools > Board” and select “Microduino/mCookie-device”
    Software Setup Guide Select Board.png

  3. Go to “Tools > Processor” and select “Microduino/mCookie-Core (328p)@16M,5V”
    Software Setup Guide Select Processor.png

  4. Only have the red Core module and yellow battery stacked. Then connect the MicroUSB to the yellow battery and the other end to your computer's USB port.
    MBattery-b.jpg

  5. Check if the red LED is lit on the yellow battery. This indicates the battery is ON and SUPPLYING power to the modules.
    If there is no red LED lit, then press and hold the button on the yellow battery for a few seconds to turn it on.
    Note: Blinking blue LEDs indicates the battery is CHARGING ONLY. 
    IMPORTANT: The red LED must be on when programming or using your project.
    MBattery-t.jpg

  6. Go to “Tools > Port” and select the port. It is usually the one that is select-able.
    Software Setup Guide Select Port Selection.png

  7. With the default sample code. Hit upload (right arrow icon on the top left of the software).
    Software Setup Guide Select Upload.png

  8. The code will compile and will say upload complete if successful. Congratulations the software setup is complete!
    Software Setup Guide Select Done Upload.png

Retrieved from "https://wiki.microduinoinc.com/index.php?title=Template:Setup_mBattery_with_Core_(Windows)&oldid=21818"