Getting started: mDesigner for Windows

From Microduino Wiki
Revision as of 21:22, 22 October 2018 by Sonny (talk | contribs)
Jump to: navigation, search

The guide below is a software setup guide for mDesigner (v1.6) under the Windows platform aimed for use with Itty Bitty Buggy.

Download

Download the latest mDesigner (v1.6) (for Windows): HERE

MDesigner Download.png

Installation

  • Open the downloaded file from the link above. You'll be asked administrator privileges.
  • Select if you want to create a desktop shortcut or not for mDesigner. Click Next.

MDesigner v1.6 InstallGuide For Windows 01.png

  • The next screen will prompt you to start the installation. Click Install to begin installing mDesigner.

MDesigner v1.6 InstallGuide For Windows 02.png

  • The installer will begin installing files into C:\Program Files (x86)\mDesigner.

MDesigner v1.6 InstallGuide For Windows 03.png

  • Wait for the file coping progress to complete.

MDesigner v1.6 InstallGuide For Windows 04.png

  • A new window will pop up to begin the driver installation. Drivers are needed to communicate with the Microduino hardware. Click Next.

MDesigner InstallGuide For Windows 05.png

  • The next screen will display the drivers that will be installed. Click I accept this agreement in order to allow the drivers to install.
  • Click Next to begin the driver installation.

MDesigner InstallGuide For Windows 06.png

  • Drivers have been installed. Click Finish to exit driver installation.

mDesigner_InstallGuide_For_Windows_07.png

  • A new window will pop up to inform that mDesigner has completed installing. Click Finish to launch mDesigner.

MDesigner v1.6 InstallGuide For Windows 08.png

  • mDesigner will start loading.

MDesigner v1.6 InstallGuide For Windows 09.png

  • mDesigner will complete loading and will be ready to use.

MDesigner v1.6 InstallGuide For Windows 10.png