Difference between revisions of "Lesson 5--Microduino “LED Brightness and Potentiometer PWM”"
Line 44: | Line 44: | ||
</source> | </source> | ||
===map() function=== | ===map() function=== | ||
− | * | + | *Function: Maps a certain range of values to a different range |
− | * | + | *Parameters: map(value, fromLow, fromHigh, toLow, toHigh) |
− | ** | + | **value: value to be mapped |
**fromLow: Start value of source range | **fromLow: Start value of source range | ||
− | ** | + | **fromHigh: End value of source range |
− | ** | + | **toLow: Start value of target range |
**toHigh: End value of target range | **toHigh: End value of target range | ||
Latest revision as of 07:20, 12 September 2016
Language: | English • 中文 |
---|
ContentsObjectiveIn the last lesson, we used a button to generate PWM to control the LED. Now, we will use a precision potentiometer to control the LED. The difference between the two is that a button uses a digital signal (0 and 1) to control the LED. A potentiometer uses an analog signal to generate PWM which is a linear change of state, so the LED's brightness can be changed clearly and gradually. Another downside of using a button is that electronic interference can cause unintended noise. That was why we had to add a pull-up/pull down resistor to our button.
Equipment
Experiment Schematic
The LED connects to any PWM output pin. The center pin of the potentiometer connects to analog ports A0 ~ A5. The potentiometer's other two pins connect to GND and 5V. The analog interface can measure 0-5V, and analogRead() returns corresponding values 0-1024. Programvoid setup()
{
pinMode(3,OUTPUT); //Choose the PWM output Port
}
void loop()
{
int val= analogRead(A0); //Read the analog port A0's value(voltage range is 0-5V,corresponding value is 0-1204)
val = map(val, 0, 1023, 0, 255);
//We want to map the analog value(0~1024)to(0~255) since the max PWM value is 255.
analogWrite(3, val);
} map() function
ResultAs you turn the potentiometer, the LED's brightness changes gradually. Video |