Microduino NRF Wireless Gateway based on Enc Gateway -304 KIT
OutlineProject:Microduino Enc gateway's NRF communication Objective:Set up a network using Microduino Enc, PC and router,using the Microduino NRF to control LED in local network. Difficulty:Elementary Time-consuming:Tow hours Maker:Microduino Studio-YLB | |||||||||||||||||||||||||||||
Bill of Materials
| |||||||||||||||||||||||||||||
Document | |||||||||||||||||||||||||||||
DebuggingStep 1:Set up hardware Control master: Equipment:Microduino-Core+, Microduino Duo-V, Microduino-Enc, Microduino-nRF24, Router and network cables. Control slave: Equipment:Microduino-Core, Microduino-nRF24 and Microduino-FT232R | |||||||||||||||||||||||||||||
Step 2: Set up network Power on router, and connect the PC to network. Step 3: Download program Start Arduino IED, open the Microduino example program, master board type choose "Microduino Core +(Atmega644P@16M,5V)", slave board type choose "Microduino Core (Atmega328P@16M,5V)", download directly. Step 4: Control LED in local network Open a new web page, enter into your ip address. Microduiono networking success can enter the control interface, or can not be opened. | |||||||||||||||||||||||||||||
ResultAfter download, Microduino core accessed the network, then open the gateway, click button on control interface to control the corresponding node led, each time you press the button, the led will have a state transition. Because it is a node control, so only the node that slave program seted can be controled by the gateway control interface's node. | |||||||||||||||||||||||||||||
Note
Video |