Microduino NRF Wireless Gateway based on Enc Gateway -304 KIT

From Microduino Wiki
Revision as of 03:44, 25 August 2014 by Pkj (talk) (Outline)
Jump to: navigation, search
Language: English  • 中文

Outline

Project:Microduino-NRF Wireless Communication Based on Microduino-Enc Gateway

Objective:To set up a network with Microduino-Enc, PC and router,using Microduino-NRF to control the LED in the LAN.

Difficulty:Elementary

Time-consuming:Two-hour

Maker:Microduino Studio-YLB

Bill of Materials

  • Microduino equipment:
Module Number Function
Microduino-Core+ 1 Master,send control signal (you can use Microduino-Core too)
Microduino-Core 1 Slave,receive control signal
Microduino-FT232R 1 Download program
Microduino-Enc 1 Network communication
Microduino-nRF24 2 Wireless communication between master and slave
Microduino Duo-V 1 Easy to debug and install
  • Other equipment:
Router one
Network cable one
micro usb data cable Two
LED one
304201KIT-module

Document

Debugging

Step 1:Set up hardware

Control master:

Equipment:Microduino-Core+, Microduino Duo-V, Microduino-Enc, Microduino-nRF24, Router and network cables.

Control slave:

Equipment:Microduino-Core, Microduino-nRF24 and Microduino-FT232R

304201KIT-system

Step 2: Set up network

Power on router, and connect the PC to network.

Step 3: Download program

Start Arduino IED, open the Microduino example program, master board type choose "Microduino Core +(Atmega644P@16M,5V)", slave board type choose "Microduino Core (Atmega328P@16M,5V)", download directly.

Step 4: Control LED in local network

Open a new web page, enter into your ip address. Microduiono networking success can enter the control interface, or can not be opened.

Myip

Result

After download, Microduino core accessed the network, then open the gateway, click button on control interface to control the corresponding node led, each time you press the button, the led will have a state transition. Because it is a node control, so only the node that slave program seted can be controled by the gateway control interface's node.

Note

  • Microduino Enc must be used with Microduino RJ45 together.
  • Need configure the MAC address and ip address in local network.
  • The gateway node and slave machine node should be matched.

Video

http://v.youku.com/v_show/id_XNjY1NzE3NDQ0.html