Selecting board, processor, and port
From Microduino Wiki
In order to upload programs onto Core modules, the correct board, processor and port needs to be selected.
Contents
Selecting the Board and Processor
Selecting the Board Type and Processor is required to compile the correct code for the core module.
Configuring the software is done under Tools > Board and Tools > Processor.
Below is the table which lists all the core modules with corresponding Board and Processor. The table also lists kits that contain specific core modules.
Example usage would be for the Core module in Itty Bitty City. Board is Microduino/mCookie-Core (328p) and Processor is Atmega328P@16M,5V.
| Name | Board | Processor | Contained in Kit |
|---|---|---|---|
| Core (168pa) | Microduino/mCookie-Core (168pa) | Atmega168pa@8M,3.3V | |
| Atmega168pa@16M,5V | |||
| Core (328p) | Microduino/mCookie-Core (328p) | Atmega328P@8M,3.3V | |
| Atmega328P@16M,5V | Itty Bitty City Kit, X02 Series Kits: 102 Basic Kit; 202 Advanced Kit; 302 Expert Kit | ||
| Core+ (644pa) | Microduino/mCookie-Core+ (644pa) | Atmega644pa@16M,3.3V | |
| Atmega644pa@16M,5V | 302 Expert Kit | ||
| Core+ (1284pa) | Microduino/mCookie-Core+ (1284pa) | Atmega1284pa@8M,3.3V | |
| Atmega1284pa@16M,5V | |||
| CoreUSB | Microduino/mCookie-Core USB (32u4) | USB | X01 Series Kits: 101 Basic Kit; 201 Advanced Kit; 301 Expert Kit |
| CoreRF | Microduino/mCookie RF (128rfa1) |
Determining Processor Variant
Core
Core+
Selecting the Port
Port selection is dependent on which programmer is connected. But it is usually the only select-able port in the list.
If there is no select-able port ensure that:
- the hardware connections are secure and correct
- the drivers are installed.
