Sensor-Dust

Language:	English  • 中文

Microduino-Dust Microduino-Dust is a PM2.5 sensor. Sensor Pin Introduction Pins of the sensor: PIN1: GND PIN2: VCC General signal pins: PIN3(IO1): digital/analog signal PIN4(IO2): NC(null) Special signal pins: If it is IIC: IO1/IO2 are respectively SDA/SCL. If it is soft serial port: IO1/IO2 are respectively tx/rx. Special to Sensor-Dust sensor pins PIN1: GND PIN2: VCC PIN3(IO1): Soft serial port tx PIN4(IO2): Soft serial port rx Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub. Features Adopt SHARP GP2Y1010AUOF air quality sensor; Independent air duct and fast detection speed; Specification Working voltage: 4.5V~5.5V Detection sensitivity: 0.5V/0.1mg/m3 1.27mm-spacing 4Pin-to-6Pin interface; Soft serial port (D4,D5) communication. Document Schematic: File:Microduino Dust.Zip Development Microduino-Dust can be applied in outdoor air quality detection or indoor dust detection. Application All hardware needed: Microduino-CoreUSB, Microduino-sensorhub, Microduino-IO split, a USB cable and several wires; Make sure you build Microduino IDE or refer to: Microduino Getting started Program #define FAN_PIN 10 //Fan control pin #define LED_PIN 12 //Sensor LED control pin #define DUST_PIN A0 //Sensor detection #define TIME1 280 #define TIME2 40 #define TIME3 9680 int dustVal = 0; float dustVoltage = 0; float dustDensity = 0; void setup(){ Serial.begin(9600); pinMode(FAN_PIN, OUTPUT); pinMode(LED_PIN, OUTPUT); digitalWrite(FAN_PIN, LOW); } void loop(){ digitalWrite(FAN_PIN, HIGH); //Open the fan before detecting delay(3000); digitalWrite(FAN_PIN, LOW); //Close the fan after 3s delay digitalWrite(LED_PIN,LOW); //Turn on LED inside the sensor delayMicroseconds(TIME1); //Wait for 280us dustVal = analogRead(DUST_PIN); //Analog value sampling delayMicroseconds(TIME2); // Wait for 40us digitalWrite(LED_PIN,HIGH); //Turn off the LED delayMicroseconds(TIME3); dustVoltage = dustVal * (5.0/1024.0); //Convert the analog value to voltage value. dustDensity = 0.17 * dustVoltage - 0.1; //Convert the voltage value to dust density (Output unit: mg / m³) Serial.println(dustDensity); delay(1000); } Software: Stack all modules together and then connect the Dust sensor's fan control interface with the D10 pin of the Sensorhub with a wire. Connect Microduino-Dust sensor's control detection interface to the IO splitter's IN interface with a wire. And then connect the IO splitter's A-OUT interface to Sensorhub A0, the IO splitter's *B-OUT interface to Sensorhub D12. Open Arduino IDE, copy the program to IDE and then choose the right board from Tools→Board and then compile. Select the right port from Tools→Serial Port in Arduino IDE after compiling, then download program. After the download, you can open the serial monitor. After the Dust sensor's fan works for three seconds, the serial console will display the current air dust density and the Dust sensor will have another detection after one second. Purchase History Pictures Front File:Microduino-Dust-F.JPG Microduino-Dust Front Back File:Microduino-Dust -b.JPG Microduino-Dust Back