Difference between revisions of "Sensor-Temperature-D1"

From Microduino Wiki
Jump to: navigation, search
(Specification)
Line 37: Line 37:
  
 
*Connection
 
*Connection
*This sensor can e connected to the I2C interface of the core.  
+
**This sensor can e connected to the I2C interface of the core.
  
 
==Document==
 
==Document==

Revision as of 08:10, 8 November 2016

Language: English  • 中文
Microduino-Sensor-Temperature-D1

The product number of Sensor-Temperature-D1 is: MSDT11

Sensor-Temperature-D1 is digital temperature detection sensor module.

LM75 is a temperature sensor produced by National Semiconductor whose output voltage is of Celsius scale.

Introduction of the Sensor Pin

Sensor backpin.png
  • Pins of the sensor:
    • PIN1: GND
    • PIN2: VCC
    • General signal pins:
      • PIN3(IO1): digital/analog signal
      • PIN4(IO2): NC(null)
    • Special signal pins:
      • If it is IIC: IO1/IO2 are respectively SDA/SCL.
      • If it is soft serial port: IO1/IO2 are respectively tx/rx.
  • Special to Sensor-Temperature-D1 sensor pins
    • PIN1: GND
    • PIN2: VCC
    • PIN3(IO1): SDA
    • PIN4(IO2): SCL


Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub.

Features

  • Adopts LM75 temperature whose address is optional.
  • With high accuracy and sensitivity.
  • With low power consumption, long service life and good stability.
  • With wide working voltage.
  • With small size which is easy to install.

Specification

  • Sensor voltage
    • 3.3V~5V working voltage
  • Size of the sensor
    • Size of the board: 23.5mm*13mm
    • 1.27mm-spacing 4Pin interface connected with sensorhub
    • CAD drawing of the sensor: File:Sensor CAD.zip
  • Technical parameters
    • Accuracy: temperature 0.125℃;
    • Measuring range: 55℃~+125℃;
  • Connection
    • This sensor can e connected to the I2C interface of the core.

Document

Development

Program Download

Programming

  • Follow the Software Getting Started Guide.
  • Select the Board, Processor and Port.
  • Click [File]->[Open], browse to the project program address, and click "Sensor_Temperature_D1_Test.ino" to open the program.
  • After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

  • Referring to the following diagram, connect the Sensor-Temperature-D1 to theI2C interface of Microduino-Sensorhub.


Microduino-sensorhub I2C.JPG


Result

  • After download, open the serial monitor.
  • The serial monitor will print out the configuration information of the sensor, and then display the current temperature in cycle.

Application

It can be used to detect the humidity of the environment, and be sued as temperature switch to control the air conditioner, fan and other devices.


Purchase

History

Gallery

  • Front
Microduino-LM75 Front
  • Back
Microduino-LM75 Back