Difference between revisions of "Sensor / Trinket Template"

From Microduino Wiki
Jump to: navigation, search
(Microduino Series)
(mCookie Series)
Line 33: Line 33:
  
 
==mCookie Series==
 
==mCookie Series==
 +
*1x of the following core module:
 +
**mCookie Core
 +
**mCookie Core+
 +
**mCookie CoreUSB
 +
**mCookie CoreRF
 +
*1x of the following core programmers:
 +
**mCookie USB-TTL
 +
**mCookie mBattery (built-in programmer)
 +
*1x mCookie Connector Hub
 +
*1x Connector Wire
 +
*1x USB Cable

Revision as of 22:47, 31 January 2019

Microduino Crash-rect.jpg

Introduction

The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.

Technical Specifications

  • SKU / module number: MSDS11
  • Operating voltage: 5V
  • Connectors: n/a
  • Chip Used: n/a
  • Schematics: File:Na
  • Dimensions:

Compatible Pins

Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.

This module requires a digital input compatible pin as shown below:

image of compatible pins

Hardware Setup

The bare minimum hardware configurations to used this module is as follows:

Microduino Series

  • 1x of the following core module:
    • Microduino Core
    • Microduino Core+
    • Microduino CoreUSB
    • Microduino CoreRF
  • 1x Microduino USBTTL
  • 1x Microduino Connector Hub
  • 1x Connector Wire
  • 1x USB Cable

mCookie Series

  • 1x of the following core module:
    • mCookie Core
    • mCookie Core+
    • mCookie CoreUSB
    • mCookie CoreRF
  • 1x of the following core programmers:
    • mCookie USB-TTL
    • mCookie mBattery (built-in programmer)
  • 1x mCookie Connector Hub
  • 1x Connector Wire
  • 1x USB Cable