Difference between revisions of "Sensor / Trinket Template"

From Microduino Wiki
Jump to: navigation, search
(Microduino Series)
(Hardware Setup)
Line 26: Line 26:
 
*1x Microduino Connector Hub
 
*1x Microduino Connector Hub
 
*1x Connector Wire
 
*1x Connector Wire
*1x USB Cable
 
 
*'''1x Crash Sensor'''
 
*'''1x Crash Sensor'''
  
Line 34: Line 33:
 
*1x mCookie Connector Hub
 
*1x mCookie Connector Hub
 
*1x Connector Wire
 
*1x Connector Wire
*1x USB Cable
 
 
*'''1x Crash Sensor'''
 
*'''1x Crash Sensor'''
  
Line 40: Line 38:
 
*1x mCenter+ (built-in mCookie Core+ & programmer)
 
*1x mCenter+ (built-in mCookie Core+ & programmer)
 
*1x Connector Wire
 
*1x Connector Wire
*1x USB Cabvle
 
 
*'''1x Crash Sensor'''
 
*'''1x Crash Sensor'''

Revision as of 22:52, 31 January 2019

Microduino Crash-rect.jpg

Introduction

The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.

Technical Specifications

  • SKU / module number: MSDS11
  • Operating voltage: 5V
  • Connectors: n/a
  • Chip Used: n/a
  • Schematics: File:Na
  • Dimensions:

Compatible Pins

Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.

This module requires a digital input compatible pin as shown below:

image of compatible pins

Hardware Setup

The bare minimum hardware configurations to used this module is as follows:

Microduino Series

  • 1x of the following core module: Microduino Core, Microduino Core+, Microduino CoreUSB, or Microduino CoreRF
  • 1x Microduino USBTTL
  • 1x Microduino Connector Hub
  • 1x Connector Wire
  • 1x Crash Sensor

mCookie Series

  • 1x of the following core module:, mCookie Core, mCookie Core+, mCookie CoreUSB, or mCookie CoreRF
  • 1x of the following core programmers: mCookie USB-TTL, or mCookie mBattery (built-in programmer)
  • 1x mCookie Connector Hub
  • 1x Connector Wire
  • 1x Crash Sensor

mCookie Series (using mCenter+)

  • 1x mCenter+ (built-in mCookie Core+ & programmer)
  • 1x Connector Wire
  • 1x Crash Sensor