Difference between revisions of "Sensor / Trinket Template"

From Microduino Wiki
Jump to: navigation, search
(Arduino IDE)
(Arduino IDE)
 
(9 intermediate revisions by the same user not shown)
Line 55: Line 55:
 
digitalRead(pinNum)
 
digitalRead(pinNum)
 
</syntaxhighlight>
 
</syntaxhighlight>
* Description: Reads the current value of the Crash Sensor.
+
 
* Arguments:
+
{|
** pinNum - the pin number that the Crash Sensor is connected to.
+
|'''Description:'''
* Return:  
+
|Reads the current value of the Crash Sensor.
**'''true''' or '''high''' when the Crash Sensor is NOT pressed.
+
|-
**'''false''' or '''low''' when the Crash Sensor is pressed.
+
|'''Arguments:'''
 +
|pinNum - the pin number that the Crash Sensor is connected to.
 +
|-
 +
|'''Return:'''
 +
|'''true''' or '''high''' when the Crash Sensor is NOT pressed.
 +
|-
 +
|
 +
|'''false''' or '''low''' when the Crash Sensor is pressed.
 +
|}

Latest revision as of 20:37, 22 February 2019

Microduino Crash-rect.jpg

Introduction

The Microduino Crash Sensor is module which can detect if it is pressed or not. It acts a button or switch.

Technical Specifications

  • SKU / module number: MSDS11
  • Operating voltage: 5V
  • Connectors: n/a
  • Chip Used: n/a
  • Schematics: File:Na
  • Dimensions:

Compatible Pins

Use a connector wire to connect this module to either a Microduino Hub module, mCookie Hub module, mCenter+, or any other boards which accepts the standard 4-pin connector for a sensor / trinket.

This module requires a digital input compatible pin as shown below:

image of compatible pins

Hardware Setup

The bare minimum hardware configurations to used this module is as follows:

Microduino Series

Microduino Crash-rect.jpg
  • 1x of the following core modules: Microduino Core, Microduino Core+, Microduino CoreUSB, or Microduino CoreRF
  • 1x Microduino USBTTL
  • 1x Microduino Connector Hub
  • 1x Connector Wire
  • 1x Crash Sensor

mCookie Series

Microduino Crash-rect.jpg
  • 1x of the following core modules: mCookie Core, mCookie Core+, mCookie CoreUSB, or mCookie CoreRF
  • 1x of the following core programmers: mCookie USB-TTL, or mCookie mBattery (built-in programmer)
  • 1x mCookie Connector Hub
  • 1x Connector Wire
  • 1x Crash Sensor

mCookie Series (using mCenter+)

Microduino Crash-rect.jpg
  • 1x mCenter+ (built-in mCookie Core+ & programmer)
  • 1x Connector Wire
  • 1x Crash Sensor

Usage

Arduino IDE

Digital Read

digitalRead(pinNum)
Description: Reads the current value of the Crash Sensor.
Arguments: pinNum - the pin number that the Crash Sensor is connected to.
Return: true or high when the Crash Sensor is NOT pressed.
false or low when the Crash Sensor is pressed.