Difference between revisions of "Servo (use with mDesigner)"
From Microduino Wiki
| Line 100: | Line 100: | ||
<br style="clear: left;" /> | <br style="clear: left;" /> | ||
</div> | </div> | ||
| + | |||
| + | =Blocks= | ||
Revision as of 23:16, 15 June 2018
The Servo is an actuator with precise position control. The angle of the arm (called the Servo Horn), can be controlled. Connectivity to an mCookie project is accomplished with the used of Hub Connector Cables and a Servo Board. Support for this module is found in mDesigner.
Compatible Pins
The following pins on the Hub or mCenter+'s Hub support this module:
| Pin Name | Compatibility | Notes |
|---|---|---|
| Pin 0 | Yes | Not recommended, Pin 0 & 1 used by mDesigner (serial communication). |
| Pin 1 | Yes | Not recommended, Pin 0 & 1 used by mDesigner (serial communication). |
| Pin 2 | Yes | |
| Pin 3 | Yes | |
| Pin 4 | Yes | |
| Pin 5 | Yes | |
| Pin 6 | Yes | |
| Pin 7 | Yes | |
| Pin 8 | Yes | |
| Pin 9 | Yes | |
| Pin 10 | Yes | |
| Pin 11 | Yes | |
| Pin 12 | Yes | |
| Pin 13 | Yes | |
| Pin A0 | Yes | |
| Pin A1 | Yes | |
| Pin A2 | Yes | |
| Pin A3 | Yes | |
| Pin A6 | Yes | |
| Pin A7 | Yes | |
| Pin I2C | No |
