Difference between revisions of "Servo (use with mDesigner)"

From Microduino Wiki
Jump to: navigation, search
(Compatible Pins)
Line 2: Line 2:
  
 
=Compatible Pins=
 
=Compatible Pins=
A use of a Servo Connector and Hub Connector cables are required to connect a Servo to a project.
+
A use of a Servo Connector and Hub Connector cables are required to connect a Servo to a project.<br>
 
The following pins on the '''Hub''' or '''mCenter+'s Hub''' support this module:
 
The following pins on the '''Hub''' or '''mCenter+'s Hub''' support this module:
 
<div style="width: 80%;">
 
<div style="width: 80%;">

Revision as of 23:23, 15 June 2018

The Servo is an actuator with precise position control. The angle of the arm (called the Servo Horn), can be controlled. Connectivity to an mCookie project is accomplished with the used of Hub Connector Cables and a Servo Connector. Support for this module is found in mDesigner.

Compatible Pins

A use of a Servo Connector and Hub Connector cables are required to connect a Servo to a project.
The following pins on the Hub or mCenter+'s Hub support this module:

Hub Digital Pins v2-01.png
Pin Name Compatibility Notes
Pin 0 Yes Not recommended, Pin 0 & 1 used by mDesigner (serial communication).
Pin 1 Yes Not recommended, Pin 0 & 1 used by mDesigner (serial communication).
Pin 2 Yes
Pin 3 Yes
Pin 4 Yes
Pin 5 Yes
Pin 6 Yes
Pin 7 Yes
Pin 8 Yes
Pin 9 Yes
Pin 10 Yes
Pin 11 Yes
Pin 12 Yes
Pin 13 Yes
Pin A0 Yes
Pin A1 Yes
Pin A2 Yes
Pin A3 Yes
Pin A6 Yes
Pin A7 Yes
Pin I2C No


Blocks