Microduino NRF Wireless Gateway based on Enc Gateway -304 KIT

Language:	English  • 中文

Outline Project: Microduino-NRF Wireless Communication Based on Microduino-Enc Gateway Objective: To set up a network with Microduino-Enc, PC and router，using Microduino-NRF to control the LED in the LAN. Difficulty: Elementary Time-consuming: Two-hour Maker: Microduino Studio-YLB

Bill of Materials Microduino equipment: Module Number Function Microduino-Core+/Microduino-Core 1 It is served as a host machine,sending control signal Microduino-Core 1 It is served as a slave machine, receiving control signal Microduino-FT232R 1 For program download Microduino-Enc 1 For network communication Microduino-nRF24 2 For wireless communication between the host and the slave machine Microduino Duo-V 1 For ease of building the circuit and debugging Other equipment: Router one Network cable one Micro USB cable Two LED one 304201KIT-module

Document

Debugging Step 1: Build the hardware Master machine control: Equipment: Microduino-Core+, Microduino Duo-V, Microduino-Enc, Microduino-nRF24, Router and network cables. Slave machine control: Equipment: Microduino-Core, Microduino-nRF24 and Microduino-FT232R

304201KIT-system

Step 2: Router network Power the router and connect the PC to network. Step 3: Download the program Start Arduino IED, open the Microduino example program and choose "Microduino Core +(Atmega644P@16M,5V)" as the board of the master machine and "Microduino Core (Atmega328P@16M,5V)" as the board of the slave machine, then download directly. Step 4: Control the LED in the LAN Open a new webpage, enter your IP address and you'll enter the control interface if you can connect the network successfully.

Myip Result After finishing the download and getting the Microduino core networked, you can just open the gateway, click the ImageButton on the control interface to control the LED. Every time you click the button, the LED will have a status transmission, by which wireless network control can be achieved. Since it is a node-control, only the node set by the slave machine program can be controlled by the corresponding node of the gateway control interface.

Note Microduino Enc must be used with Microduino RJ45 together. Networking the devices needs to configure MAC and IP address of the Ethernet interface in the LAN. The node of the gateway and the slave machine should be matched. Video