Temperature D1 (use with mDesigner)

From Microduino Wiki
Jump to: navigation, search

The Temperature (D1) sensor is a capable of measuring the current temperature near the sensor. Support for this sensor is found in mDesigner.

Microduino-LM75.jpg

Note:

Several sensors may be similar, but this page only covers the TEMP.D1 sensor.

Compatible Pins

The following pins on the Hub or mCenter+'s Hub support this module:

Hub I2C Pins.png
Pin Name Compatibility Notes
Pin 0 No
Pin 1 No
Pin 2 No
Pin 3 No
Pin 4 No
Pin 5 No
Pin 6 No
Pin 7 No
Pin 8 No
Pin 9 No
Pin 10 No
Pin 11 No
Pin 12 No
Pin 13 No
Pin A0 No
Pin A1 No
Pin A2 No
Pin A3 No
Pin A6 No
Pin A7 No
Pin I2C Yes Any I2C / IIC pin.


Block

Temperature/Humidity Read

This block reads the temperature (in Celsius) from the sensor and returns the value.

Note: This block looks very similar to the Temperature/Humidity Read block used with the Temperature & Humidity S2 sensor. Ensure you are using the correct block!
MDesigner Temperature D1 Read.png
Reads and returns the temperature (in Celsius) from the sensor.