View source for LM75 Temperature Detection

{| style="width: 800px;"
|-
|
=Function of the Module=
*'''Please refer to: [[Temperature & Humidity Sensor]]'''
*Temperature range: -40-80℃. This sensor is not water-proof so you can't put it into the water and measure temperature and humidity.  

==Overview==
To use the Temp& Hum sensor to detect surround temperature and humidity and check data in the serial monitor. 

==Bill of Material==
*Module  
{|class="wikitable"
|-
|Module||Number||Function 
|-
|[[mCookie-CoreUSB]]||1||Core board 
|-
|[[mCookie-Hub]]||1||Sensor pin board 
|-
|[[Microduino-Temp&Hum]]||1|| Temperature and humidity sensor 
|}

*Other Hardware Equipment 
**One USB cable  
[[File:Temp-Hum.jpg|600px|center]]

==Hardware Buildup==
*Setup 1：Connect the Temp&Hum sensor to the IIC port of the Hub. (Only connected to IIC) 
[[file:mCookie-Temp&Hum-sensor.JPG|600px|center]]
*Setup 2：Connect the CoreUSB, Hub and Temp&Hum sensor to the computer with a USB cable.  
[[file:mCookie-Temp&Hum-pc.JPG|600px|center]]

==Mixly ==
*Step1：Since we use the serial monitor, we need to find "Serial communication" from "Communication" item.
[[File:mixly_Serial.jpg|400px|center]]
*Step2：Serial communication description. 
[[File:mixly_Serial_complian.jpg|600px|center]]
*Step3：Find "Temp&Hum module " from "Sensor" under the item of "Microduino". 
[[File:mixly_intemp.jpg|600px|center]]
*"Temp&Hum module " description 
[[File:mixly_digital-temp-in.jpg|600px|center]]
*You can find "Print" in "Text" if you need to print self-defined content. 
[[File:mixly_text.jpg|600px|center]]
* Overall code description. 
[[File:mixly_digital-temp-in-serial.jpg|800px|center]]

==Debugging==
*Step1：Select the right board card(Core USB 32U4) and COM port(Recognized automatically by default). 
[[File:mixly_board_COM.jpg|400px|center]]
*Step2：Open the serial monitor. 
[[File:mixly_COMXX.jpg|400px|center]]
*Step3：Make sure the serial baud rate is the same with the pre-set one.
[[File:mixly_COMXX_ok.jpg|400px|center]]
*Step4：Check the data: When hold the sensor with your hand, the temperature and humidity will increase but the humidity is climbing faster that temperature.  
[[File:mixly_COMXX_data—temp.jpg|400px|center]]