Difference between revisions of "Sensor-Shake"

From Microduino Wiki
Jump to: navigation, search
(Features)
Line 19: Line 19:
  
 
==Features==
 
==Features==
*With small size;
+
*With small size which is easy to install;
 
*With adjustable detection sensitivity.
 
*With adjustable detection sensitivity.
 +
*With good detection flexibility.
  
 
==Specification==
 
==Specification==

Revision as of 03:52, 18 September 2016

Language: English  • 中文
Microduino-Shake

The product number of Sensor-Shake is: MSDS51

Sensor-Shake is vibration detection sensor module.

Resistance strain vibration sensor is a kind of vibrating sensor which expresses the mechanical vibration quantity of the tested object by with the resistance variation.。

Sensor Pin Introduction

Sensor backpin.png
  • Pins of the sensor:
    • PIN1: GND
    • PIN2: VCC
    • General signal pins:
      • PIN3(IO1): digital/analog signal
      • PIN4(IO2): NC(null)
    • Special signal pins:
      • If it is IIC: IO1/IO2 are respectively SDA/SCL.
      • If it is soft serial port: IO1/IO2 are respectively tx/rx.
  • Special to Sensor-Shake sensor pins
    • PIN1: GND
    • PIN2: VCC
    • PIN3(IO1): Digital signal input
    • PIN4(IO2): NC


Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub.

Features

  • With small size which is easy to install;
  • With adjustable detection sensitivity.
  • With good detection flexibility.

Specification

  • Sensor voltage
    • 3.3V~5V working voltage
  • Size of the sensor
    • Size of the board: 23.5mm*13mm
    • 1.27mm-spacing 4Pininterface connected with sensorhub
    • CAD drawing of the sensor: File:Sensor CAD.zip
  • Function description
    • After shaking the sensor, the digital output will change from 0 into 1.
  • Connection
    • This sensor can be connected to the following ports of the core: D2~D13

Document

Development

Program Download

Programming

  • Follow the Software Getting Started Guide.
  • Select the Board, Processor and Port.
  • Click [File]->[Open], browse to the project program address, and click "Microduino_Sensor-Shake_Test.ino" to open the program.
  • After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

  • Referring to the following picture, connect Sensor-Crash to the digital port D6 of Microduino-Sensorhub.


Microduino-sensorhub Shake.JPG


Result Observation

  • After download, open the serial port monitor.
  • After the sensor is shaking, the digital output changes from 0 into 1.

Application

  • Shake switch

Project

Purchase

History

Gallery

File:MicroduinoShake-F.JPG
mCookie-Shake-Front
File:Microduino-Shake-b.JPG
mCookie-Shake-Back