Latest revision as of 14:24, 23 March 2016

Function of the Module

Please refer to:Microduino-TOUCH
Capacitive touch sensor module
Sensing distance: 0-8mm(The distance is the longest when the material is non conducting medium.)

Setup 1：Connect the interface on the back of the touch sensor with the D6 port of the Hub, which is the control pin of the sensor. Users can change that on your own. Pins available for the Hub is 0, 2. 4, 6, 8, 10 and 12.

Setup 2：Connect the CoreUSB, Hub and touch sensor together to the computer with a USB cable.

The touch sensor programming is the same with the key programming. The only difference is the capacitive sensing mode. For the key, it is mechanical sensing mode. Please refer to 【Key-press】

@@ Line 16: / Line 16: @@
 |[[mCookie-Hub]]||1||Sensor pin board
 |-
-|[[Sensor-Touch Button]]||1||Touch sensor
+|[[Microduino-TOUCH]]||1||Touch sensor
 |}
@@ Line 31: / Line 31: @@
 [[file:mCookie-Touch-pc.JPG|600px|center]]
 ==Mixly Programming==
-*The touch sensor programming is the same with the key programming. The only difference is the capacitive sensing mode. For the key, it is mechanical sensing mode. Please refer to '''【[[Keypress]]】'''
+*The touch sensor programming is the same with the key programming. The only difference is the capacitive sensing mode. For the key, it is mechanical sensing mode. Please refer to '''【[[Key-press]]】'''
 |}