Difference between revisions of "Temperature D1 (use with mDesigner)"
From Microduino Wiki
(→Temperature/Humidity Read) |
|||
| Line 112: | Line 112: | ||
::[[File:MDesigner_Temperature_D1_Read.png]] | ::[[File:MDesigner_Temperature_D1_Read.png]] | ||
| + | :Reads and returns the temperature (in Celsius) from the sensor. | ||
Latest revision as of 21:49, 3 July 2018
The Temperature (D1) sensor is a capable of measuring the current temperature near the sensor. Support for this sensor is found in mDesigner.
|
Note: |
Compatible Pins
The following pins on the Hub or mCenter+'s Hub support this module:
| Pin Name | Compatibility | Notes |
|---|---|---|
| Pin 0 | No | |
| Pin 1 | No | |
| Pin 2 | No | |
| Pin 3 | No | |
| Pin 4 | No | |
| Pin 5 | No | |
| Pin 6 | No | |
| Pin 7 | No | |
| Pin 8 | No | |
| Pin 9 | No | |
| Pin 10 | No | |
| Pin 11 | No | |
| Pin 12 | No | |
| Pin 13 | No | |
| Pin A0 | No | |
| Pin A1 | No | |
| Pin A2 | No | |
| Pin A3 | No | |
| Pin A6 | No | |
| Pin A7 | No | |
| Pin I2C | Yes | Any I2C / IIC pin. |
Block
Temperature/Humidity Read
This block reads the temperature (in Celsius) from the sensor and returns the value.
| Note: This block looks very similar to the Temperature/Humidity Read block used with the Temperature & Humidity S2 sensor. Ensure you are using the correct block! |
- Reads and returns the temperature (in Celsius) from the sensor.
